|
This is the simple version without motor mounts and GoPro Gimbal.
Short descriprtion: Middle size QUADcopter frame with space for ESC inside frame, easy to replace landing legs.
Optional stabilised GoPro camera mount, better motor mounts.
Materials: Black fiberglass G10/G11 1-2mm thick, square aluminium tubes 10x10x1mm
Size: <> 480mm diameter with motor mounts (motor to motor distance), <> 455mm diameter with motor mounted directly to the arms.
Weight: Frame alone <> 255g.
<> 975g RTF with Emax 2822 or similar motors with 8” propellers, including camera mount, GoPro camera and LiPo 2200mAh,
<> 1175g RTF with Turnigy 2213/22 or similar motors with 10” propellers, including camera mount, GoPro camera and LiPo 2200mAh.
Propellers size: 8-10 inch will fit. I'm using 8x4.5" propellers.
Included parts: Power Distribution Board, velcro for LiPo mount, two spare arms, one spare langing leg (two fiberglass elements).
Not included:
motors, ESC, radio, flight controller etc
Description: Middle size QUADcopter frame with optional stabilised GoPro camera mount. Frame is prepared for typical motors with 16 or 22mm mounting hole distance - you can mount motors like Emax 2822, RCtimer 2822 directly to the arms or motors like Rctimer, Turnigy to motor mount. Motor 750-1200kV are recemended wit 8-10 propellers. Using motor mount you can fit motor wires inside arms. Space for LiPo is under frame. Typical flying time is <> 10-13min (with 2200-3300mAh LiPo, depending of flying style). You can use many different fly controller in typical 50x50mm size, Arducopter controller etc
Optional 2-axis GoPro mount: You can buy in promotional price 2-axis GoPro camera mount. Camera stabilizer was tested with TowerPro MG90, Hitec HS-65HB, EMAX ES08MD servos The best is IMHO EMAX servo - much better than others. This GoPro mount is prepared for directly use with Lunar Lander 4 frame and works fine with MultiWii fly controller. This mount set include all needed fiberglass elements, screws, spacers, snap-bals but don’t include servos!
Flying with camera can be very funny but can be very dangerous for your camera too. Remember that in case of hard crash you can easy destroy your expensive equipment - you fly on your own responsibility!
Tested and RECOMMENDED configuration:
Motor mounted directly to the arms - 1200kV motors for example RCtimer CF-2822/14, Emax 2822 with 10-12A ESCs
- TowerPro MAG 12A, Turnigu Plush 12A-E. 8" propellers like EPP 8x4.5, GWS 3-blade 8".
Motor mounted using motor mounts - 700-1000kV motors for example RCtimer A-2830/14, Turnigy 2217/20 860kV
with 10-12A ESCs - TowerPro MAG 12A, Turnigu Plush 12A-E. 10" propellers like EPP 10x4.5.
Remember than ANY motors and propellers should be ballanced before you will try to fly!
Assembly guide:
Sample videos:
The specifications and designs are subject to be changed without prior notice for futher improvement.
|
